Jun 22, 2009 · To configure a system to accept Finger protocol requests (defined in RFC 742), issue the ip finger command in global configuration mode.

Mar 26, 2018 · This module describes the basic tasks that you can perform to manage the general system features of the Cisco IOS software.

Hi Gurus, I have turned off the command, no service finger but somehow it is not displaying at the running config.How can i do it?

Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in ...

To define and enable a line-in-use message, use the refuse-message command in line configuration mode. To disable the message, use the no form of this command.

Good morning,. I have found in few manuals that Finger service must be disabled for security reason. Is it because it leaves a port open to exploitation?

The service finger command has been replaced by the ip finger command. However, the service finger and no service finger commands continue to function.

The Cisco enhanced EtherSwitch service modules connect to Cisco 2900 series and Cisco 3900 series routers through the service module console Gigabit Ethernet ...